Approach Tech DVR-3024MD Uživatelský manuál stáhnout pdf (Strana 60)

58

1.

Make sure that the key

is unlocked.

2.

Pull the active-handle

outward to detach the

carrier body from the

mobile rack.

3.

Slide the top cover

backward and remove.

4.

Setting the jumper of

your hard disk driver.

The way to set the

jumper of the drive

varies between

manufacturers; please

refer to the instructions

on the driver to set the

jumpers in the master

position.

5.

Attach the interface

connector and the

power connector to the

drive. Please note the

red lining of the IDE

cable and the red wire

of power cable must

line up side by side.

6.

Place the HDD inside

mobile rack. Use four of

the provided screws.

7.

Place the top cover

back to the carrier

body by sliding

forward to secure.

8.

Slide the carrier body

back in the mobile rack.

9.

Push the carrier body

further into the mobile

rack until fully inserted.

10.

Push the active-handle

inward.

11.

Lock the Key.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 66 67

Komentáře k této Příručce

Žádné komentáře