Approach Tech DVR-3704T Uživatelský manuál stáhnout pdf (Strana 27)

The user needs to see the situation in each channel in order to set a detection zone within the 8W

×6H (48) area. The effective points are marked “ ” (red) and the ineffective points are marked

“ ” (yellow).

The user can use the manual mode to set the target area. Please press the “^”, “v”, “<” or “>”

buttons to select the points, and use the Enter button to mark them one by one; or press the

Save button to activate the whole points.

5.5.4 NETWORK SETTING

ADVANCED SETTING NETWORK SETTING

1.RECORD SETTING ENTER

1.NETWORK PASSWORD 9999

2.ALARM SETTING ENTER

2.PORT DATA/CMD 5000/5001

3.MOTION SETTING ENTER

3.IP ADDRESS 192.168.001.224

4.SUBNET MASK 255.255.254.000

4.NETWORK SETTING ENTER

5.GATEWAY 192.168.001.254

5.SCHEDULE SETTING ENTER

1. NETWORK PASSWORD:

The default admin password is 9999.

2. PORT DATA/CMD: The option is to set the transfer ports of the image data and command data.

Note: The values of DATA/CMD ports must be the same with the setting of the Network Viewer

software (refer to chapter 7).

3. IP ADDRESS: The IP

address may be manually edited.

4. SUBNET MASK: The IP mask may be manually edited.

5. GATEWAY: The gateway may be manually edited.

NOTE: When only one unit of the DVR is connected to a computer or LAN, you can freely

assign an IP address for the DVR. For example, there is a range of DVR IP addresses from

192.168.1.1 to 192.168.1.255. You can pick one for use from the range of the IPs. It’s not

necessary to set MASK and GATEWAY; leave the settings as default.

When a DVR is connected to a WAN, you must acquire a unique, permanent IP address

and correctly configure the MASK and GATEWAY settings according to your network

architecture. If you have any questions regarding these settings, please contact a qualified

MIS professional or your ISP.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 46 47

Žádné komentáře

Approach Tech DVR-3704T Uživatelský manuál Strana 27